Author Topic: MAV408DAWW  (Read 1085 times)

Offline NGC

  • VIP Member
  • Member Since: Aug 2012
  • Posts: 3
MAV408DAWW
« on: August 12, 2012, 12:04:07 PM »
Went to put the clothes in the dryer and found that the washer did not spin them out. What maybe causing this problem?

Offline haroldsappliance

  • Technician
  • Member Since: Nov 2011
  • Posts: 612
  • Country: us
    • Appliance repair
Re: MAV408DAWW
« Reply #1 on: August 12, 2012, 02:29:50 PM »
Is it making any noise? Check your pump if it is. That would b a start. These pumps r known to go out, but they are also known to make some noise. Also check your belt.
35-6780
21352320

Offline Bailey

  • Technician
  • Member Since: Dec 2011
  • Posts: 572
  • Country: us
Re: MAV408DAWW
« Reply #2 on: August 12, 2012, 08:42:14 PM »
Did you turn the timer back around to the spin cycle and try it again?

Offline NGC

  • VIP Member
  • Member Since: Aug 2012
  • Posts: 3
Re: MAV408DAWW
« Reply #3 on: August 12, 2012, 08:46:23 PM »
yes I tried it in the spin cycle a few times, it does not do anything or make any sounds during the spin cycle.

Offline Bailey

  • Technician
  • Member Since: Dec 2011
  • Posts: 572
  • Country: us
Re: MAV408DAWW
« Reply #4 on: August 12, 2012, 08:53:15 PM »
So when you checked them at the end of the cycle you have a full tub of water? If the washer is dead during the spin cycle, check the lid switch. Shut the lid then slowly lift it about 2 inches. You should hear a click at he back of the lid.

Offline NGC

  • VIP Member
  • Member Since: Aug 2012
  • Posts: 3
Re: MAV408DAWW
« Reply #5 on: August 12, 2012, 09:04:01 PM »
It's full of water and I don't hear a click. What's next? Thanks.

Offline Bailey

  • Technician
  • Member Since: Dec 2011
  • Posts: 572
  • Country: us
Re: MAV408DAWW
« Reply #6 on: August 13, 2012, 12:22:56 PM »
There is a wiring diagram in the control panel. The next step is to check the contacts in the lid switch with an ohm meter.

Offline haroldsappliance

  • Technician
  • Member Since: Nov 2011
  • Posts: 612
  • Country: us
    • Appliance repair
Re: MAV408DAWW
« Reply #7 on: August 13, 2012, 04:03:07 PM »