MAV408DAWW

[NGC]

Went to put the clothes in the dryer and found that the washer did not spin them out. What maybe causing this problem?

[haroldsappliance]

Is it making any noise? Check your pump if it is. That would b a start. These pumps r known to go out, but they are also known to make some noise. Also check your belt.
35-6780
21352320

[Bailey]

Did you turn the timer back around to the spin cycle and try it again?

[NGC]

yes I tried it in the spin cycle a few times, it does not do anything or make any sounds during the spin cycle.

[Bailey]

So when you checked them at the end of the cycle you have a full tub of water? If the washer is dead during the spin cycle, check the lid switch. Shut the lid then slowly lift it about 2 inches. You should hear a click at he back of the lid.

[NGC]

It's full of water and I don't hear a click. What's next? Thanks.

[Bailey]

There is a wiring diagram in the control panel. The next step is to check the contacts in the lid switch with an ohm meter.

[haroldsappliance]

12001187