Author Topic: Frigidaire refrigerato ice dispenser auger runs non-stop  (Read 380 times)

Offline penut

  • VIP Member
  • Member Since: Jul 2012
  • Posts: 1
Frigidaire refrigerato ice dispenser auger runs non-stop
« on: July 30, 2012, 10:46:45 AM »
Frigidaire PLHS269ZDB2 - I replaced water dispenser actuator, but while doing that, the ribbon cable was accidentally unplugged. I put everything back, turned on the power, the Ice dispenser auger runs non-stop. Here are the things I’ve tried:

1. Disconnect the wire on micro switch for ice dispenser, the auger still runs.

2. Re-connect the micro switch, and disconnect the ribbon cable, then ice auger stops.
When power is on and Ice dispenser auger running, all the lights on control board (the one right behind the face plate)(241708307) are on except the lock light. When I push any buttons on the control board, no response, no light will be off, they all stay on. If I push and hold the lock button, the red lock light will be on. With lock light on, I opened the freezer door, auger stops; closed door, auger still off; push and hold the lock button again, lock light off and auger runs again and.

Is this a problem with control board (241708307) or power board(241708102)? Or something else?



 

Frigidaire Refrigerator Ice Dispenser Problems

Started by TechnicianBrian

Replies: 1
Views: 3425
Last post February 25, 2013, 10:27:19 AM
by Dlr8475
frigidaire frig ice dispenser model # frsl3lr5es0

Started by repairguy42

Replies: 2
Views: 400
Last post March 04, 2012, 11:06:08 AM
by bigbuck
Frigidaire French Door LGUB2642LF2 auger motor help

Started by markinfla1963

Replies: 1
Views: 455
Last post August 01, 2012, 07:03:11 PM
by haroldsappliance
Kenmore refrigerator - how remove ice/water dispenser front panel

Started by Marvster

Replies: 1
Views: 16164
Last post August 11, 2007, 08:06:07 PM
by AJ
No water from dispenser-ice maker working-replaced valve inlet

Started by Evan

Replies: 2
Views: 1790
Last post August 18, 2007, 05:17:53 PM
by Evan
kenmore ice dispenser

Started by brad

Replies: 4
Views: 2365
Last post September 15, 2007, 05:09:18 AM
by brad