Maytag Clock for MER6770AAB

[dlucas729]

Bought refurbished clock.  Confused as to where the wires go. 

[AJ]

Hi,

Don't your refurbished clock look the same as the original? Should just be a matter of transferring the wires from the original clock to the refurbished one.
 
Maytag Range Model Number MER6770AAB uses Clock Assembly Part # 12001661

Here is the service manual for that model. Maybe the wiring diagram will help.
http://appliancejunk.com/forums/index.php?action=downloads;sa=view;down=390

[dlucas729]

I thought I was mailing it in for repair so I took the old one out.  I labeled the wires went but I have sone doubts.  The orange, tan, blue, and yellow wires.  A black wire coming out of the white block and the black wire with a jumper.

[AJ]

Could you post some photos of what your working with?

[dlucas729]

Try this out

[dlucas729]

The 1st board was bad.  I had my board repaired.  I studied the board and discovered that it tells you where to place the wires.  Checking the black wires.  Black wire coming out of L1 and goes to L1L and then jumps to L1U.  There is now an L1A that comes from above.  I thought it connected to L1U, but the bottom broil is on all the time.   I did an ohm check with the wires disconnected and the relays are doing what the should.  Upper bake (left 2 relays open and the right 2 closed and ....).   Now what?