Not sure if anyone can help, but I need help diagnosing an issue with my washer. I have been working on my Kenmore washer for a couple weeks and have so far replaced the drain pump and motor coupler. I have also removed the tub for no other reason than i did not know what i was looking for before I replaced the coupler. Now after the coupler repair the washer started spinning slowly until finally it doesn't spin at all. The agitator is also not working. I could hear the motor running when in the agitation and spin cycles, but no movement. I pulled the motor again and the couple is still OK, so now I do not know what the problem can be. I am sure that I can fix the problem, but I do not know how to diagnose the issue to know what to fix. I am at my wits end here and do not know what to do. Any help would be greatly appreciated.