Author Topic: Duet wfw8300sw05  (Read 984 times)

Offline zwingli

  • VIP Member
  • Member Since: Aug 2011
  • Posts: 34
Duet wfw8300sw05
« on: June 19, 2012, 08:27:42 PM »
I replaced the control board (not the MCU) in this machine. The display was flickering and the machine would stop in mid load. It did not set any codes . After replacing the board and powering up it worked for a few loads and then started acting up. The diagnostics do not work and it doesn't set any codes. It starts a load and the minutes on the timer will go back and forth between the time and 8. The display will start flickering and then the machine will shut down. I did all the component checks in the tech sheet and everything checks out. I didn't check the motor though.
Any help would be appreciated.
Thanks.

wfw8300sw05

donate
$1, $2, $5, $10, $20, $50
 

Photos: Whirlpool Duet washer with bad bearings, only 2.5 years old!

Started by AJ

Replies: 21
Views: 31394
Last post May 23, 2013, 08:22:19 PM
by Rick32k
Video: Whirlpool Duet Front Load Washer Water Pump Clean Out.

Started by AJ

Replies: 0
Views: 6063
Last post November 28, 2007, 09:58:47 PM
by AJ
How to replace a Whirlpool Duet washer bellow tub door seal

Started by AJ

Replies: 39
Views: 71206
Last post December 24, 2013, 12:16:46 AM
by GB-NC
Whirlpool Duet Sport Error f-01

Started by Ology

Replies: 2
Views: 7147
Last post March 10, 2008, 05:20:36 PM
by Repair-man
Whirlpool duet sport keeps on pumping

Started by hinkelberry

Replies: 3
Views: 1691
Last post March 10, 2008, 10:05:03 PM
by apptech
Whirlpool Duet Washer - F-30 error code and clunking noise in detergent area.

Started by AJ

Replies: 3
Views: 13125
Last post November 15, 2009, 09:34:58 AM
by AJ