Author Topic: Maytag Neptune Very Noisy During Spin  (Read 3218 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
    • TechnicianBrian.com
Maytag Neptune Very Noisy During Spin
« on: April 24, 2008, 10:14:55 PM »
Model #MAH4000AWW, this unit was washing fine, but during the spin cycle would start making a loud noise. After removing the rear access panel, it was apparent that the rear bearing has seen better days. Sometimes the bearings will fail due to age, but often, their life span is shortened by using the wrong detergent or to much detergent. By using non he detergent or excessive amounts of detergent, large amounts of suds will be the result and these suds will allow water to come into contact with the rear bearing seal and eventually over time, get to the bearings themselves. So to prevent an expensive repair, use the correct detergent, and the correct amount as recommended by your washer manufacturer. This unit is 9 years old and the customer decided to go shopping instead of continuing with the repair. But had they wanted it done, a lip seal kit and basket support would be used to get it back in working order.




MAH4000AWW
« Last Edit: April 24, 2008, 10:32:03 PM by AJ »

 

Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 62101
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag Neptune Washer - No Spin

Started by AJ

Replies: 6
Views: 6439
Last post February 20, 2008, 12:41:13 PM
by AJ
maytag noisy when agitating noise chenges with direction spin quiet

Started by funbiz99

Replies: 9
Views: 3805
Last post March 03, 2008, 08:07:48 PM
by JWWebster
Maytag Neptune Mah4000aww will not go through cycles or spin...

Started by Mudd222

Replies: 11
Views: 5376
Last post April 23, 2013, 11:14:30 AM
by def
Maytag Washer Noisy During Spin

Started by TechnicianBrian

Replies: 0
Views: 1941
Last post April 24, 2008, 10:14:55 PM
by TechnicianBrian
Maytag Neptune Washer - LR on display and no spin

Started by AJ

Replies: 0
Views: 4711
Last post May 05, 2008, 07:00:37 PM
by AJ