Watch this video and get step-by-step how to instructions on how to replace the belt on a Frigidaire top load washer. This is a easy repair that you can do with only a putty knife and a philips screwdriver.
Archive for the 'Video' Category
This video will show you step-by-step on how to register for a free account at appliancejunk.com forums so you can start to take advantage of the many benefits of being a member.
This video shows step-by-step instructions on replacing the Door Boot Seal on Frigidaire, Electrolux, Crosley and Kenmore Front-Load Washers, part # 134728400
http://youtu.be/k6J1IU2zdK0
In Amana Iowa there is a unquie pride in keeping the turn of the 20th centery theme alive.
It was in the late 1800′s when Frederick Maytag arived by covered wagon as a child. In 1907 Maytag turned it sights on appliance and the rest is history. Amana knows refrigerators. They manufactured the frist side by side in 1949.
The people of Amana take price in there work. Over 20 percent of them have been building appliance for over 30 years. The Amana Iowa plant is more then 2 million square feet. Housing about 2000 employes.
They do more then assemble refrigerators in Amana. They test them for reliability. Robots open and close doors and draws over and over to test the life of the product. They even put sensors in different parts of the refrigerator to be sure your milk stays cold. But it does not stop there. Each day they test to make sure the packaging will hold up to the long ride it may have to your home.
With the heritage of the folks at Amana you can be confident that a Maytag refrigerator from Amana Iowa was built with dependability in mind. Iowa will forever be the birth place of Maytag and dependability.
Maytag knows what’s inside matters.
This video shows you Step-By-Step Instructions on how to test the Heating Element for an electric dryer.
In this video I show you how to remove the food chopper in a whirlpool dishwasher so it can be cleaned or replaced. If the top arm of your dishwasher is not rotating around it could be because the food chopper screen is plugged restricting the amount of water going through the pump. If this happens sometimes you can simply clean the food chopper screen, but most of the time it’s best to replace the food chopper because the blade has been damaged.
Often times I find a noisy dishwasher also has something stuck in the food chopper. In this case simply removing the food chopper and cleaning it takes care of the noise.
This video show you how to test a dishwasher heating element with a multimeter.
Testing and replacing a bad heating element in a dishwasher is a simple repair job that any one can do.
Simply set your multimeter to ohms and check the element for continuity. If you have continuity across the element then it is good. If you do not have continuity across the heating element then it is bad and it will need to be replaced.
If you have a bad dishwasher heating element you may notice the cycles take longer to finish and the dishwasher does not get things clean like it use to.